Residential Epoxy Flake Floor in Greenville, SC

Dolerite Marble Blend — Joint Repair and Surface Leveling Before Full Broadcast Flake in Northeast Greenville

Zachary Daniel Concrete installed a full broadcast Dolerite marble epoxy flake floor in Northeast Greenville, South Carolina — a sophisticated blend of dark gray, charcoal, and white marble-pattern chips that gives the surface the refined look of polished stone with the durability and slip resistance of a commercial-grade epoxy system. The homeowner came to ZDC with two specific pain points: dirty concrete joints that had accumulated grime and debris over time, and a low spot in the field where water was pooling — a problem Zach calls a bird bath — rather than draining away from the surface.

Both issues needed to be addressed at the substrate level before any coating could go down. The ZDC crew ground the entire floor smooth to flatten the surface, filled the low spot to eliminate the pooling area, repaired and filled the concrete joints so the finished surface would be seamless instead of cracked and open, and then applied the epoxy system on a prepared, level substrate. The Dolerite marble blend went down as a full broadcast over the base coat — scattered to rejection across the wet surface, scraped and vacuumed flat, and sealed with a UV-stable top coat for long-term durability.

The result is a floor durable enough to install in an automotive center and refined enough to elevate a residential space — exactly what a marble-pattern flake blend like Dolerite is designed to deliver. Call Zach at (864) 770-8608 if you have concrete joints that need addressing, a surface that pools water, or a floor that deserves a finish like this.